Biochars Impact on Soil-Moisture Storage in an Ultisol and Two Aridisols


    loading  Checking for direct PDF access through Ovid

Abstract

Biochar additions to soils can improve soil-water storage capability; however, there is sparse information identifying feedstocks and pyrolysis conditions that maximize this improvement. Nine biochars were pyrolyzed from five feedstocks at two temperatures, and their physical and chemical properties were characterized. Biochars were mixed at 2% wt wt−1 into a Norfolk loamy sand (Fine-loamy, kaolinitic, thermic Typic Kandiudult), a Declo silt loam (Coarse-loamy, mixed, superactive, mesic xeric Haplocalcid), or a Warden silt loam (Coarse-silty, mixed, superactive, mesic xeric Haplocambid). Untreated soils served as controls. Soils were laboratory incubated in pots for 127 days and were leached about every 30 days with deionized water. Soil bulk densities were measured before each leaching event. For 6 days thereafter, pot-holding capacities (PHC) for water were determined gravimetrically and were used as a surrogate for soil-moisture contents. Water tension curves were also measured on the biochar-treated and untreated Norfolk soil. Biochar surface area, surface tension, ash, C, and Si contents, in general, increased when produced under higher pyrolytic temperatures (≥500°C). Both switchgrass biochars caused the most significant water PHC improvements in the Norfolk, Declo, and Warden soils compared with the controls. Norfolk soil-water tension results at 5 and 60 kPa corroborated that biochar from switchgrass caused the most significant moisture storage improvements. Significant correlation occurred between the PHC for water with soil bulk densities. In general, biochar amendments enhanced the moisture storage capacity of Ultisols and Aridisols, but the effect varied with feedstock selection and pyrolysis temperature.

    loading  Loading Related Articles