Influence of cement type and ceramic primer on retention of polymer-infiltrated ceramic crowns to a one-piece zirconia implant
AbstractStatement of problem.
The best procedure for cementing a restoration to zirconia implants has not yet been established.Purpose.
The purpose of this in vitro study was to measure the retention of polymer-infiltrated ceramic crowns to zirconia 1-piece implants using a wide range of cements. The effect of ceramic primer treatment on the retention force was also recorded. The retention results were correlated with the shear bond strength of the cement to zirconia and the indirect tensile strength of the cements to better understand the retention mechanism.Material and methods.
The retention test was performed using 100 polymer-infiltrated ceramic crowns (Vita Enamic) and zirconia implants (ceramic.implant CI) The crowns were cemented with either interim cement (Harvard Implant semipermanent, Temp Bond), glass-ionomer cement (Ketac Cem), self-adhesive cement (Perma Cem 2.0, RelyX Unicem Automix 2, Panavia SA), or adhesive cement (Multilink Implant, Multilink Automix, Vita Adiva F-Cem, RelyX Ultimate, Panavia F 2.0, Panavia V5 or Panavia 21) (n=5). Additionally ceramic primer was applied on the intaglio crown surface and implant abutment before cementation for all adhesive cements (Multilink Implant, Multilink Automix: Monobond plus; RelyX Ultimate Scotchbond Universal; Vita Adiva F-Cem: Vita Adiva Zr-Prime; Panavia F2.0, Panavia V5: Clearfil Ceramic Primer) and 1 self-adhesive cement containing 10-methacryloyloxydecyl dihydrogen phosphate (MDP) (Panavia SA: Clearfil Ceramic Primer). Crown debond fracture patterns were recorded. Shear bond strength was determined for the respective cement groups to polished zirconia (n=6). The diametral tensile strength of the cements was measured (n=10). Statistical analysis was performed using 1-way or 2-way analysis of variance followed by the Fisher LSD test (α=.05) within each test parameter.Results.
Adhesive and self-adhesive resin cements had shear bond strength values of 0.0 to 5.3 MPa and revealed similar retention forces. Cements containing MDP demonstrated shear bond strength values above 5.3 MPa and displayed increased retention. The highest retention values were recorded for Panavia F 2.0 (318 ±28 N) and Panavia 21 (605 ±82 N). All other adhesive and self-adhesive resin cements attained retention values between 222 ±16 N (Multilink Automix) and 270 ±26 N (Panavia SA), which were significantly higher (P<.05) than glass-ionomer (Ketac Cem: 196 ±34 N) or interim cement (Harvard Implant semipermanent: 43 ±6 N, Temp Bond: 127 ±13 N). Application of manufacturer-specific ceramic primer increased crown retention significantly only for Panavia SA.Conclusions.
Products containing MDP provided a high chemical bond to zirconia. Self-adhesive and adhesive resin cements with low chemical bonding capabilities to zirconia provided retention force values within a small range (220 to 290 N).